Full Traction Suspension Bolt on SOA Kit
|
|
| FTS's Bolt on YJ & CJ Spring Over Kit |
Short Cuts |
|
by: Full Traction Suspension
|
|
 |
| Full Traction Suspension's bolt on YJ & CJ
Spring Over Kit. |
Engineered to bolt-on the vehicle without drilling or welding, the
Full-Traction Jeep SPOA kit finally provides the installer an easy way to
mount the springs over the axle on JEEP Cj’s & Yj’s. Unique design
provides approx 4.5” of lift and can be used with Factory Jeep springs,
Full Traction springs or other aftermarket leaf springs. Designed to
maintain proper steering geometry and pinion angle, the FTS one-piece
laser crafted axle spring perch is the only of its kind available. Mounts
to Dana axle and uses the factory center pin to eliminate guesswork during
installation. The complete kit includes front and rear perches reinforced
for increased strength, integrated one-piece bump stop limiters, front and
rear U-bolt skid plates and all required hardware. Precision lazer cut
components provide the installer ease of installation making this the best
way to achieve a spring over. Powder coat finish.
Kit shown with optional Shocks & Sway Bar Disconnects
Key Benefits
The first complete bolt-on system available. No welding or grinding
required to install.
Ramp travel at over 1100 out of the box.
This site and all original materials contained herein are Copyright © 1999 - 2008 by OutdoorWire, Inc.. -- All Rights Reserved.
The use of this website, OutdoorWire, or any of its publications or services is subject to the terms of use agreement.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire are all trademarks and publications of OutdoorWire, Inc.
