TOY: RE: Re: New Engine Update

["Payne, Mike K." <MPayne1@xxxxxxxxxxxx>]

Thanks for the heads up, I will do that...  any high grade grease fine, or
does anyone have a preference?

> -----Original Message-----
> From:	C. Andrew Zook [SMTP:andyzook@mail.pdqlocks.com]
> Sent:	Monday, February 05, 2001 5:11 AM
> To:	toyota@4x4wire.com
> Subject:	TOY: Re: New Engine Update
> 
> > So far, we had a small water leak from the water pump that was fixed
> after
> a
> > couple turns with a ratchet,  the oil thing, a small exhaust leak fixed
> the
> > same way as the water leak, now one of the injectors is leaking (O-Rings
> > were replaced)... so tomorrow we will be pulling the no. 1 injector to
> try
> > and find the hold up.
> 
> Did you lube the orings? If not, I would suggest removing all of them and
> replacing them. Coat them liberally in grease before you install them.
> 
> I am speaking from experience here... I had a REALLY bad leak, fixed that
> one, and had another one burst about a month down the road (I had sliced
> it
> when I installed it). I bought a new set, lubed 'em up, and have had no
> problems since!
> 
> CAZ
> 
> 4x4Wire.com Toyota Section http://www.4x4wire.com/toyota/