Re: TOY: Mystery x-case part

[Jim Brink <toytech@xxxxxxxxxxx>]

Drew Persson wrote:
 
> >Subject: TOY: Transfer case part?
> >I took apart my spare transfer case last night and while tapping the
> >reduction box off with a rubber mallet a small piece fell out.  I had the
> >2wd/4wd case separated and all the gears off the shaft when this part fell
> >out.  The part is about an inch long and looks kinda like a medicine
> >capsule.  I looked all over to try and find a place that this piece would
> >fit but could not.  Does any one know where it goes?
> >Kendall
 
> "Interlock pin", prevents the t-case from moving from 4WD to 2WD while in
> low-range, or from hi-range to low-range while in 2WD.
 
Everyone beat me to this one...This pin goes between the high/low and
front drive shifter shafts. You can install it once you install one or
the other shifter shaft and fork through the threaded hole with the
torx-head cap.

--
Jim Brink
Toyota/ASE Certified Technician
Manhattan Beach, CA
Technical Toyota Editor-4x4Wire.com - http://www.4x4wire.com/toyota/