Re: TOY: New throttle body setup (22RE)

["Karl Bellve, Ph.D." <Karl.Bellve@xxxxxxxxxxxx>]

I believe you have to atleast adjust the throttle body set screw first.
You close the throttle body all the way, then back out the set screw a
few turns. The exact procedure is in the manual. Then you can adjust the
idle speed.


Roger Brown wrote:
>
> Anyone have any tips on setting up the idle air valve on a new throttle body?
> I've looked in the Toyota repair manual and they only mention setting a
> specific idle speed after everything else is set.
>
> What I'm looking for is some place to start with, like "all the way in and two
> turns back".
> I did try setting it like my old one, but that didn't seem to be correct (that
> was about 4 turns out).
> 4x4Wire.com Toyota Section http://www.4x4wire.com/toyota/

- --
Cheers,

Karl Bellve			ICQ # 13956200
1985 4Runner SR5		TLCA# 7938

Old Man Emu lift, Toyota Electric Locker, TJM-13 Bumper, REP8000 winch,
Stout Equipment rear bumper, RS9000s, Persson Sway-Bar Disconnects, FJ40
vented rotors and IFS calipers