Re: JPOR: Pig shaving :)

["Randy Peterson" <rkpete@xxxxxxxxxxxxxx>]

Subject: Re: JPOR: Pig shaving :)


> ****************Please Remember to snip your replies***************
> I used a portable band saw to trim a little and then cleaned it up some
> with a 4.5" angle grinder.  I really didn't remove much, but it did end
> up being about 1/4" and noticeably smoothed the bottom.  I did not get
> into any bolts.  I had to trim a little off the bottom of the cover to
> keep it above the bottom of the housing too

Have you disciovered the front D44 diff covers yet ? made if about 1/4"
steel plate. Much beefier than the stock rear dana 44 diff covers.......

Randy Peterson