Re: JPOR: Angles for Axles

["Michael C. Knorr" <michaelknorr@xxxxxxxxxxxxxx>]

B Nelson wrote:

> What are you running for angles on your front axle?

4 degrees of caster. O degree's of pinion.

>     Since I don't have any weight in my Jeep I am not
> sure if I should weld the knuckles after I shorten my
> axle, as my measurements may be off.

Why not just wait until you have your drivetrain done. Then you can put
jacks under your springs and get accurate measurements. Also where you
set your front pinion will depend on what type of front shaft you run.
CV or not. Same rules that apply to the rear shaft apply to the front if
you want to be able to run in 4wd with out any vibration.


Later,
Mike