Re: JPOR: NP435 to AMC engine question

["Michael C. Knorr" <michaelknorr@xxxxxxxxxxxxxx>]

Mo,
Use a bronco dana 20 transfercase. My buddy did this and he made his own
adapter. Evidently the 435 has the same spline output as the dana 20 input. You
just need to make an adapter to go between the two. On the plus some bronco
cases had 2.43:1 gear reduction. Much better than a 205's.
Mike Knorr

Maurice Cox wrote:

> ****************Please Remember to snip your replies***************
>
> >I hear say that the t176 bellhousing will bolt to the Np435 and your
> >motor, or at least the 6 cyl, then you need a custom pilot bushing. The
> >expensive part come when you mate the Tranny to the t/c. For a Dana 300
> >I think the adapter is around 500.00, comes with an output shaft that
> >you have to change in the transmission.
>
> Yeah, but I now need a driver side drop transfer case...like an NP205 that's
> already bolted to a Ford NP435...
>
> Mo
> ---------------
> Maurice Cox
> Cleveland, Ohio
> 81 CJ8  360/T19/NP205/D60s -- under construction
> 92 XJ   4.0/AX15/NP231
> 79 SJ   Just about gone
>
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
> *******************************************************************
>      Link to Archive, Mission Statement, Rules, Subscribe and
>            Unsubscribe instructions  are available at:
>              http://www.pclink.com/jnutter/JPOR.htm