JPOR: drilling 5-5.5" bolt circle on 6-5.5" axle shafts

[dallas hill <hill_dallas@xxxxxxxx>]

	Has anyone drilled a Wagoneer  rear axle shaft to fit the CJ 
bolt pattern.   I was thinking that I could have a template machined 
to locate the the new bolt circle.   Then I could drill the holes on 
my drill press with the right setup.   I would use one existing hole 
and have the weld in 2 of the holes.   How is everyone else doing 
this?   Does anyone know how much it costs to have Moser do this? 
You can hardly find a CJ AMC20 in the Southwest and narrow track 
Wagooner axles are plentiful and only about $125.

Thanks
Dallas Hill