Re: JPOR: Custom Axles

[John Nutter <jnutter@xxxxxxxxxx>]

Brett Davis wrote:
> 
> This might be sacrilege here, but if a guy was to pay someone to build
> a set of high-pinion, 35-spline D60s (a shop with good capacity, not
> just one-off) who would you recommend?

Probably Dynatrac. I wouldn't spend the money or take the strength loss
of the high pinion rear if I had a CJ8 though. You've got plenty of
wheel base to make the low pinion rear work right. A high pinion front
is always attractive though. 

> 
> And, balancing stability with ability, how wide (for a jeep type
> vehicle)?  60"? 64"? I believe my full-width are 68" flange to flange.

I'm thinking  61" for my next Jeep, although I"m happy with 58" on my
CJ7.  

-- 
John Nutter '85 CJ7
JeepWire.Com Editorial Staff
http://www.outdoorwire.com/4x4/jeep/

Admin for Jeepoffroad Mailing List
http://www.pclink.com/jnutter/jpor.htm

President of Trailriders 4x4 club 
http://www.mntrailriders.org/