RE: JPOR: Driveshaft

[Dave Jacobs <DJacobs@xxxxxxxxxxxxxxxxxx>]

Chris, how is your 5.0L running?

		-----Original Message-----
		From:	Chris Waterman
[mailto:Chris_Waterman@pmc-sierra.com]
		Sent:	Friday, June 09, 2000 1:43 PM
		To:	'jeepoffroad@4x4wire.com'
		Subject:	RE: JPOR: Driveshaft

		****************Please Remember to snip your
replies***************

		> I was wondering if anyone knew of a donor vehicle
		> that uses a double cardan driveshaft with a flanged
		> end that I could modify to work.

		Check out an 80's era Monte Carlo driveshaft.

		The Currie SYE I used to have had a flange-type CV
		yoke.  4-bolt pattern, about 3" apart?  I made a
		driveshaft out of a Bronco front CV shaft, with
		the "normal"-style CV yoke replaced with a flange-
		type yoke from an 80's Monte Carlo.  All 1310 joints,
		and the MC flange (with the CV ball) fit right into
		the Bronco H-block.  You could also use the whole
		Monte Carlo CV joint, and have the shaft retubed or
		cut down to size, maybe?

		Chris
	
*******************************************************************
		     Link to Archive, Mission Statement, Rules, Subscribe
and
		           Unsubscribe instructions  are available at:
		             http://www.pclink.com/jnutter/JPOR.htm