Re: JPOR: Driveshaft

["Chad Lloyd" <clloyd@xxxxxxxxx>]

This probably won't help, but I'll check with 'Jeep Thrills' when I go by
there later this week - sometimes Craig there has stuff lieing around or
something that might be useful.

Also: buddy here told me he had to find an NV4500 for a customer's vehicle,
and it was hard to come by, but when he finally found one, got it for $475.

Chad

-----Original Message-----
From: Debora L. Crooks <debric@supercity.ns.ca>
To: jeepoffroad@4x4wire.com <jeepoffroad@4x4wire.com>
Date: Friday, June 09, 2000 10:13 AM
Subject: JPOR: Driveshaft


>****************Please Remember to snip your replies***************
>I'm hoping some one on this list may be able to help. I bought a RE slip
>yoke eliminator kit a while ago, the kind where you cut the output
>yourself, but am too cheap to buy the driveshaft that goes with it.
>
>I was wondering if anyone knew of a donor vehicle that uses a double
>cardan driveshaft with a flanged end that I could modify to work. I
>looked at some Toyota stuff but their flanges are too small for my kit.
>I don't mind redrilling holes if I have to but can't think of any other
>vehicles that use this type of shaft. ANy ideas?
>
>Rico
>*******************************************************************
>     Link to Archive, Mission Statement, Rules, Subscribe and
>           Unsubscribe instructions  are available at:
>             http://www.pclink.com/jnutter/JPOR.htm
>