Re: JPOR: Tapered Reamers

[jayers@xxxxxxxxxxxxxx]

I borrowed one from a Stock Car fabricator friend of mine.  He gets them
through Behling Racing Equipment, 5170 North 125th Street, Butler, WI
53007 (800) 255-4117 Fax-(414) 783-6293.  They carry one for tie rod
ends and one for ball joints.  They use a six flute spiral.  They each
list for $119.50 which was out of my price range.  #80770 is the smaller
one at 1.5" taper per foot and #80771 is the larger one at 2" taper per
foot.  I don't know who actually manufactures them, but I couldn't find
them through any tool catalog that I could find.  Perhaps you could
check the local race car builder.  Jeff
_________________________________________________________________________
txh3202@att.net wrote:
>
> ****************Please Remember to snip your replies***************
>
> I need to buy a tapered reamer to ream out my pitman arm.
> I've already paided once to have a pitman arm reamed out
> and I figure it will be cheaper in the long run to make
> my own.  I'm not sure what type of reamer to purchase,
> does anyone know off-hand?  Looking at the catalog, there
> are Pin, Morse, and Brown and Sharpe.  I have an L&I
> catalog, does anyone have an L&I reamer out there that
> could give me a part number?
>
> --
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Terry L. Howe        http://www.jeeptech.com/~txh3202
> Colorado Springs, CO           mailto:txh3202@att.net
> '75 CJ-6, '45 CJ-2A             BH4WDC, CA4WDC, UFWDA
> ~~~~~  JeepWire Pages http://www.jeepwire.com/  ~~~~~
> *******************************************************************
>      Link to Archive, Mission Statement, Rules, Subscribe and
>            Unsubscribe instructions  are available at:
>              http://www.pclink.com/jnutter/JPOR.htm