RUST BULLET AUTOMOTIVE

OMIX-ADA Car Parts
APW LARGEST SELECTION OF AUTO PARTS
Installing TJ Flares on a YJ
4x4Wire TrailTalk Forums Galleries Search 4x4Wire
Photos by Vance Anderson Short Cuts
[ JeepTech | Engine | Transmission | Transfer Case | Drive Shaft | Axle | Wheel | Tire | Suspension | Steering | Brake | Frame | Bumper | Carrier | Body | Fuel | Electrical | Interior | Winch | Tool ]

 

p9240017.jpg p9240021.jpg p9240022.jpg p9240023.jpg
Marking the front cut line Cutting a portion of the OYR off. Front fender well cut Tac-welded seam
p9240024.jpg p9240025.jpg p9240027.jpg Dcp01738.jpg (93023 bytes)
Trimming the bottom of the flare Cutting! Cutting the front The rear flare lined up

 

Page 3 of 3

 

 

 

Please support 4x4Wire by visiting our featured sponsors
shop 4wd.com for all your Jeep Products Shop at CarParts.com and Start Saving
Support your hobby by becoming a member of BlueRibbon Coalition
 Support your hobby by participating in TreadLightly!

| 4X4Wire Portal | About 4x4Wire | Search 4x4Wire | TrailTalk Forums | Advertiser's Guide |

This site and all original materials contained herein are Copyright © 1999 - 2009 by OutdoorWire, Inc.™ -- All Rights Reserved.
The use of this website, OutdoorWire, or any of its publications or services is subject to the terms of use agreement.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News are all trademarks and publications of OutdoorWire, Inc.