Deep CJ-6: Day Five on Body Work
|
|
|
http://www.4x4wire.com/jeep/projects/deep6/day05/
|
Short Cuts |
|
|
|
By: Terry L. Howe - 4/2003
|
|
A little Bondo on the tub and the fender mounted up. The fender had a lot
of trimming done to it.
|
|
|
The grill has been wire wheeled down to bare metal.
|
|
|
The wind shield was partially cleaned up.
|
I spent most of the day at the insurance auction today trying unsuccessfully
to purchase a slide in camper that had the top ripped off. It sold for more
than I was prepared to spend. Got some work done on the Jeep at night anyway.
The grill and wind shield are wire wheeled down which completes all the major
wire wheeling at last! I sprayed both of them with the rust converter.
I bolted on the fenders which I'd cleaned up and done some major trimming
to earlier. I need to get the hood mounted up since I'd like the hinges
mounted properly before spraying.
To do something different, I broke out the Bondo and put a little on the
drivers side of the rig. I have a couple patches that need to be smoothed
out there.
This site and all original materials contained herein are Copyright © 1999 - 2008 by OutdoorWire, Inc.. -- All Rights Reserved.
The use of this website, OutdoorWire, or any of its publications or services is subject to the terms of use agreement.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire are all trademarks and publications of OutdoorWire, Inc.