was rotating my tires today. & overtorque 1 of my rear wheel stud. THe stud sheared, so I got 5 left. Is this really bad to run on hwy with until I get time to pop out the left rear axle & press out the backing plate, wheel bearings, ...etc?
(No, i didn't have torque gauge...i was using the stock wheel nut removal tool + a pipe ... )
-------------------- 91-22re(408xxxkm & counting with a rebuilt long block)- Flatbed/Camper /33x10.5BFG-AT/Open 4:88/1.5"BJS/
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.