Jim, I'll check diameter when I get home. But as I said earlier it very common socket. If you go to any auto parts store (Advanced,Autozone) amongst some other spindle nut sockets you can find one for 1/2 axle with 4 pins and one of slightly larger diameter for 3/4-1 ton axle with 6 pins. They usually are only kind with sticking out pins. I've been looking at those for a while since they appeared to have about right diameter. Initially I bought one with 4 pins (1/2 ton) but as soon as I got home I saw it was a bit too small. I went back and exchanged it for 6 pins. It was the right one.
-------------------- 92 SR, 285/75R16 Yoko MT ARB locker GAST compressor AirLift 1000 MM10500 Snorkel custom rear bumper
02 Montero LS died protecting the master
08 PowerWagon (stock!)
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.