Ok. i think I got about everything figured out. RTV is similar to the stuff for the hub mounting surface. looked up the info on the Special Socket and the alltenative screw driver and hammer. Have the all the other stuff figured up and lined up except for the drive shaft end play, but I am not to worried about that. would anyone recomend puting antiseize on the "disc to hub bolts" and any other places? Thanks for the help and the old post are helpful just time consuming sorting through them but found all kinds of other info so its all good.
-------------------- 91 Montero LS "RECON", Auto, Dual Bouncy Seats, SR rear axle with air locker, 2" Suspension lift, 2" Body Lift, GENII front IFS, 32" MT tires
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.