OK so here's the pics I promised. Lift is good, it matches my SAS with marlin springs, nice and level. I did take the next-to-shortest leaf out of the front springs. Anyhow, you can see how far it pushes the chevies down...
But as I said before, I am not sure about the flex aspect. Maybe I'll get a chance to try it out tomorrow..
And just for grins, here's one of my groovy new triple-drilled output flange from Marlin...the cause of the " actual complaint about Marlin" thread on the OT forum. Attached to it is my groovy new CV driveshaft...
...that needs shims for correction of angle at the axle...
-------------------- two 87 runners...one wrecked, one bone stock
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.