FrankR
Web Wheeler
Reged: 02/01/04
Posts: 10225
Loc: Columbia, SC
|
Re: Aisin 372-L Swap
12/04/05 10:21 PM
|
|
|
Thanks, Matt - that's what I did - at some point I have to trust my work and not the incorrect manual for this transmission - although I was told it was the same as the other A40 series. 
The bellhousing is back on and torqued down with thread sealant to protect against salt penetration into the through-threaded holes - the oil pump is installed with sealant under the bolt heads only. The clutches and brakes have been tested with low pressure air (40 psi) - all appear to be working fine and I can hear movement at every location with every shot of air:
The input shaft turns freely (well, with some effort) and has .018" end play:
The output shaft has .022" end play:
Axial Play Spec = .012-.035"
As built:
Input shaft = .018"
Output shaft = .022"
66.5 hours
Frank
--------------------
'89 G-Raider Supercharged 3.0L, MegaSquirt 2, lockup A/T, 2.5" exhaust, 155k, Cibie H4s/Oscar SCs, Hella Micro DE fogs, Cobra CB, Superwinch hubs, LSD rear/Aussie Locker front, Bilsteins, 165A alt., Lifeline AGM, Rust-Oleum
Edited by FrankR (12/04/05 10:29 PM)
|
|
Previous
Index
Next
Flat
Edit
Reply
Quote
