87Montero
Trail Leader
Reged: 11/19/03
Posts: 5576
Loc: Greenville, SC
|
Re: IT RUNS!!!
11/19/04 07:55 PM
|
|
|
Quote:
The ECU temp sensor is a two wire sensor and has an oval base.
Kevin
Gotcha, I think its hooked up correctly now, the engine was from an Automatic if it matters. I hooked the temp guage wire to the bottom connector that makes an upside down "T" and the guage seems to work normal now.
I hooked up the mass air and the hose and everything and after replacing a bad spark plug (why it ran so bad before) it seems like its starved for gas, so once I fix that I should be good to go... but other than that it idles pretty smooth after putting a timing light on it and setting it to 10* BTDC... tomorrow ill have that turbo spooling It seems to vibrate quite a bit here and there as I rev it up.. but I guess thats what taking the balance shafts out does.
Brendan
-------------------- 1999 Mitsu Montero - Fully Loaded
'92 Isuzu Pickup: V6,4x4,5spd,TJM Front Bumper,9k Winch, DOR Rear Bumper, RR Hubs, 3" Calmini Lift, 4.77s, 33" TSLs
2008 Saturn Sky Redline - 3 Pedals and a turbo :)
|
|