if you want to use that 94 axle go back and get the flange off the 94 driveshaft. They use the same u joint, I believe, so just swap at the u joint. My raider was built in '88, so that make it an 89. As otheres said above, All the 92-93 SR lockers I've seen were 9",,,and the front was 7 1/2 "high pinion" air controlled, and they were all 4.88. I think someone had a low pinion 4.88 8" front gear for sale on here recently. I think there was a problem with locker actuators, but I'm not sure which year was better or on parts available,,,something else to think about and those in the know will fill in...
-------------------- dave h.
'89 Raider V6 5spd;Aisin Hubs;M.Sport(=LS)frt. calipers; Gen2 LS: rear coils;U.C.arms;R.trailing arms;idler arm; rear LSD axle w.disc brakes;2 battery system for Dog's fan; relocated ECU; custom bumpers;J.Baker receiver;Conferr roofrack; t-bar crank.
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.