I just used my last spare. I have to pass CA Emmissions this month. I've been messing around with makeing an improved version. I cut the poorly designed flexable section out ,,,and I have section of flexy from a Toyota egr tube. I just need to weld it. I can't find anybody around here that can do it. It's some type of stainess( old timer here at NAPA knew exactly what kind). The pipe is 17mm diameter, so if you have to end up doing this , thats what to look for in the junk yards. I checked net sites for material but could only find it from manufatures in India and I would have to buy an entire shipping container full. There's alot of folks on here alot smarter than me, so maybe an solution will pop up.
-------------------- dave h.
'89 Raider V6 5spd;Aisin Hubs;M.Sport(=LS)frt. calipers; Gen2 LS: rear coils;U.C.arms;R.trailing arms;idler arm; rear LSD axle w.disc brakes;2 battery system for Dog's fan; relocated ECU; custom bumpers;J.Baker receiver;Conferr roofrack; t-bar crank.
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.