I am replacing the passenger side CV half shaft on my 89 Mitsubishi Montero. Everything was going great until I attempted to install the snap ring on the shaft. I had my son pulling the CV boot side while I tried all sorts of methods to get the snap ring into the groove. I know it is very close but I can't get the last one or two millimeters.
I have read that on other manufactures there is a threaded shaft that a bolt can be used as a press but the Montero shaft is solid.
I am out of ideas. I was hoping others have figured this out.
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.