I made sliders for my gen I using a 48" piece of .25"x2"x2" angle iron welded right to the cab. It cost me $15 in steel. And yes, it was difficult not to burn through the sheet metal. Though not the prettiest, they work, though they are about 4-5" short. I would say optimal size for gen I is 52-53".
89 Raider V6, 35s, 5sp, welded rear, 8k winch
89 Raider 2.6 going on 84 4runner frame
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.