justice
Roll Me Over
Reged: 02/06/00
Posts: 3163
Loc: Coastal N Carolina, USA
|
Re: Did anyone get the np231 t-case to work on gen1 auto?
07/01/09 06:22 PM
|
|
|
If you want to use the long shaft, why not just cut a spacer out of 1/4" (or 3/8) flat stock? since your spacing between two flat surfaces you would only have to ensure that the bolt holes are drilled in the right spot and the hole in the center is large enough for the shaft to pass through. the outside shape would not matter..Seems easy to me. I think this is getting way overthunk  If I didnt have the aussie gears I would have tried this one already..but for now its on you guys.
The splines match...Get R Done!
--------------------
99 Gen 2.5, fixing, awaiting build
89 SWB- 33's, ARB Front locker, SR rear locker/axle, SR F brakes, winch, WST Offroad Armor all Around, 2.85 Aussie T-case Gears
Sold: (2) 95 SR's, 86 SWB, 90LWB, 91 LWB
-Can Change a timing belt in my sleep..
|
|
Previous
Index
Next
Flat
Edit
Reply
Quote
