Wednesday: I completed the welding of driver side tube fender. I adjusted the top plate and welded it in place. I also cut out the passenger side top plate.
Once both tube fenders are complete, I will start to work on a 3" fender flair.
Thursday: Yesterday I took a piece of 20 x 17 steel plate and traced the two bottom pieces:
I cut out one of the pieces and trim it to fit:
I also cut out the passenger side fenders. I already had removed the airbox in a prior mod so the only thing to remove was the fuse/relay box. I cut the fender with it still installed on the jeep. I should be able to remove the rear and front screws and remove the outer fender with very little effort.
Today is my daughters birthday so not much work will get done. On Saturday I should finish the passenger side.
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.