Quote: 1. Is there a write up on performing a 22RE install with cross-over to fuel injection to a previously non fuel injected truck ? 2. What all will I need from the Fuel injected vehicle to perform the cross-over ? 3. Does the intake manifold (carburated) or exhaust manifold swap over to the 22RE ?, as I remember one does the other does not.
There are a few differences in EFI and Carb, as well as motor differences from pre-84 and the 85-95 R/RE's. If you want to use your exhaust on an EFI block, you'll have to find a 82-84 Celica to get the correct block. Otherwise, you'll be looking at an 85-95 block and need the exhaust manifold as well. Best way to do the conversion is to have a donor vehicle - and a 2wd will work as well, except for the difference in oil pan/pickup tube, but you can use your current one for that. If you want to keep the Carb, you'll need to find a pre-84 block for your intake to bolt on, otherwise find a 85-95 block and carb intake/exhaust manifold. Hope this helps, Todd
-------------------- 1986 Toyota Pickup extracab longbed "Woody edition", No longer 2wd!
SAS - 33's, 5.29's, lockright rear
SR5 guage cluster - glowing red.
94 2wd v6 - my "DD"
04 Outback Wagon- wife's/family car
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.