My pump seal was leaking, so I needed to replace the seal. I devised a method to remove the seal without disassembling the pump. I drilled 3 small holes in the seal that a sheet metal screw will fit into:
I found a washer that fit on the shaft and drilled 3 holes in it that the screws will fit through:
I screwed the screws into the seal through the washer and used a 3 jaw puller to pull the seal:
The seal came out without damaging the shaft or housing:
The seal size is 20mm X 31mm X 7mm. I am having a hard time finding it here in the 'States. If anyone has any idea where I can get a seal soon, please let me know. Thanks, Rich
-------------------- All Diesel Fleet:
1985 Mitsubishi 2.3 Turbodiesel Pick-up, 1983 GMC Van- 6.2 Diesel.
Benzs: 1995 E300 diesel, 1980 300SD, 1982 300CD, 1983 300D, 1985 190D.
1980 AMC Eagle Limited Wagon powered by: 3.6 Litre I6 VM Turbo Diesel Engine (one of fewer than 10 made, only 2 known to still exist)
This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.