rxinhed
The Mitsubishi Parts Guy
Reged: 02/21/05
Posts: 5897
Loc: Gerber, CA
|
|
I have a few doors in various states of disassembly that I would gladly ship on your nickel. The license plate lamp is easy, too. I have some with the Mitsubishi plate and one Raider piece. Door for shipping only, the lamp assm. for coin.
PM me. 
|
RaiderGriz
Getting the Wheeling Fever
Reged: 04/24/12
Posts: 54
Loc: NE Panhandle
|
|
Found there are a couple of bouncy seats in the garage sale, is that guy still around? I have inquired without any response..I want to install a bouncy seat on both sides! Wife won't let me be the only one having one! 
--------------------
You maybe younger and can run faster, but I am older and have been around long enough to know where all the shortcuts are!
1989 MTs/Dodge Raider SWB V6 5spd - Daily Driver/Work in Progress.....
|
Howah
Getting the Wheeling Fever
Reged: 06/22/11
Posts: 32
Loc: CA, USA
|
|
Anyone has a compatible camshaft position sensor for a 95 montero sr to give away.
--------------------
95 Montero SR
|
ROCKSNMUD
Need a Spot
Reged: 10/03/11
Posts: 11
Loc: Florence, AL
|
|
I have a manual transmission pulled from a 89 mitsu mighty max p/u. It was bolted up to the 3.0L V6. There were about 175K miles on the engine, not sure of the condition of the tranny. I bought the truck non-running for the heads. I will throw the transfer case in with it since they are still bolted together.
I am located in north-west Alabama 35633. Would prefer local pickup.
You can message me on here or email Knale22@aol.com
Hope this will help someone out!
Edited by ROCKSNMUD (06/07/12 12:05 AM)
|
LandRaider
Forum Moderator
Reged: 09/04/01
Posts: 8409
Loc: Ocean Springs, MS
|
|
Quote:
I have a manual transmission pulled from a 89 mitsu mighty max p/u. It was bolted up to the 3.0L V6. There were about 175K miles on the engine, not sure of the condition of the tranny. I bought the truck non-running for the heads. I will throw the transfer case in with it since they are still bolted together.
I am located in north-west Alabama 35633. Would prefer local pickup.
You can message me on here or email Knale22@aol.com
Hope this will help someone out!
DDDANNNGGG Wish you were a LIL closer!!!
--------------------
87 Raider 4.3 700R4 NP231CHD
Solid Axles, Selectable Lockers, 36's
87 Raider 4D56td v5MT1
Almost all stock.
|
off-roader
Mitsubishi Forum Moderator
Reged: 01/16/00
Posts: 15504
Loc: Bay Area, CA
|
|
Ended up not needing them when I found an entire fan clutch and blade setup from a 3.5L sport at a pick and pull for cheap.
Let me know if you need it. 
|
ROCKSNMUD
Need a Spot
Reged: 10/03/11
Posts: 11
Loc: Florence, AL
|
|
Quote:
Quote:
I have a manual transmission pulled from a 89 mitsu mighty max p/u. It was bolted up to the 3.0L V6. There were about 175K miles on the engine, not sure of the condition of the tranny. I bought the truck non-running for the heads. I will throw the transfer case in with it since they are still bolted together.
I am located in north-west Alabama 35633. Would prefer local pickup.
You can message me on here or email Knale22@aol.com
Hope this will help someone out!
DDDANNNGGG Wish you were a LIL closer!!!
I hear ya man. I could ship on buyers dime, not sure how much it would cost at this time. But if it was something you were really interested in, then I could research it further.
Thanks
|
ROCKSNMUD
Need a Spot
Reged: 10/03/11
Posts: 11
Loc: Florence, AL
|
|
I Also have a 6g 72 block to donate to the cause. The block was removed from an 89 mitsu mighty max pickup with the same mileage as the above listed tranny and transfer case.
The block is NOT locked up and the heads have been removed. There are still some odd and end brackets bolted up that I can leave on it. The block has been sitting outside with a plastic tote on top of it. Hope someone can get some use out of it, would hate to see it get scrapped.
|
rxinhed
The Mitsubishi Parts Guy
Reged: 02/21/05
Posts: 5897
Loc: Gerber, CA
|
|
I am going to either recycle or toss some things that don't need to be on my new shelves. The parts I no longer need include Gen I Montero radio and center console in various conditions, some disassembled front doors, a grey glove box, tan 89 steering wheel with horn button, tan main gauge pod cover, 4-cyl Montero front sway bar, and more that I'll come to as I sort.
Pay shipping only on the parts above, or come by and visit.
--------------------
1987 Raider (Roxy), 1988 Mighty Max turbo (Pearl), 1987 Ramcharger (Ryan), Sundry parts and parts cars
|
d_bum
Getting the Wheeling Fever
Reged: 03/12/08
Posts: 45
Loc: Hickory, NC
|
|
Just purchased another 87 swb and this one had a set of aluminum running boards on it. I have no need for them. Free to anyone that wants them. Would rather not ship but if anyone is interested would consider that possibility.
--------------------
87 Raider 4d55t
89 Conquest Tsi
87 Montero SWB (for sale)
89 Montero LWB
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
