(Roll Me Over)

12/04/06 11:58 AM

Re: Gotta hand it to LandRaider...

Are you saying the Gap is there because the Input shaft is too long? If so how hard is the shaft to get out and are they expensive to get machined down to work? Or is there one that will work in it.

This site and all original materials contained herein are Copyright 1999 - 2013 by OutdoorWire, Inc. -- All Rights Reserved.
The use of this website, OutdoorWire, or any of its publications or services is subject to the terms of use agreement.
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
This publication and OutdoorWire, Inc. assume no liability for your use of the material contained within this site.
OutdoorWire, 4x4Wire, SUVWire, JeepWire, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc.

Contact 4x4Wire | Privacy statement

4x4Wire TrailTalk Forums

Generated in 0.003 seconds in which 0.001 seconds were spent on a total of 4 queries. Zlib compression enabled.