Tuesday, 27 August 2019
  0 Replies
  10.6K Visits

A quick internet search yielded a variety of replacement hood latches covering a variety of years. My search did note there were a few hood latches that were year specific.

I selected the Voodonala (see Figure 1) because of the style and the material was aluminum alloy with stainless steel hardware in a black matte finish.  The hood latches arrived with all parts, three Allen wrenches and a cryptic instruction sheet.  It was easy to determine that other necessary tools were 10 mm and 13 mm wrenches.

The location of the nut holding the stock hood latch provides a challenge to fit a wrench and loosen the nut.  I resorted to pulling the front grill loose.  It is held in place by seven snap-in plastic tabs across the top which must be removed.  Then, steady pressure on the lower portion was necessary to pop the retaining tabs out of their slots.  With the grille out of the way, access to the inside of the fender nut location is still tight.  There is plenty of room around the nut, but access is tight. (see Figure 2)

I was able to slip a 1/4 inch socket wrench between the fender and bracing to reach the nut.  Angles are important.  I do have a little used 1/4 inch swivel adapter in my tool box that allowed me to fit the socket on the nut and provide enough angle adjustment to loosen the nut.

The latch has two pieces, one fits on the fender and the other on the hood.  Both pieces have gaskets that fit between the latch and the body panel.  There is a rubber piece on the stock hood latch that needs to be moved to the corresponding tab on the replacement latch that fastens to the fender.  The fender mounted latch piece does nee to be disassembled to allow access to the Allen head bolt. (see Figure 3)

Once the pieces are assembled and installed, you are ready close the hood and adjust as necessary.  The latch pieces on the hood do have a little adjustment room in the bolt slots. (see Figure 4)

My previous hood latch swap used the Daystar polyurethane hood latches which can be viewed here - http://www.4x4wire.com/entry/daystar-hood-wrangler-install

Figure 1

Figure 2

Figure 3

Figure 4

Read full article

John Stewart Managing Editor - 4x4Voice - 4x4Wire - MUIRNet.net Natural Resources Consultant - California Four Wheel Drive Association - http://www.cal4wheel.com Board of Directors - BlueRibbon Coalition http://www.sharetrails.org

There are no replies made for this post yet.
Be one of the first to reply to this post!

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting. Copyright (c) 1999-2020 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission. You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material. All corporate trademarks are the property of their respective owners.