4x4Wire News-Bytes

4x4Wire News-Bytes features news and information about OHV recreation and environment issues around the nation. (Site registration required to post)
  1. John Stewart
  2. Automotive
  3. Sunday, September 09 2012, 07:50 PM

[img]pictures/articles/jeep/daystar-hood/dsc_0158-1.jpg[/img]Every JK owner will notice that strange little hood movement known as “hood flutter”.  That is when you pass a semi on an windy day and you see your hood start to lift.  The 2007 and newer JK Wrangler stock hood latches are prone to stretching which allows movement of the hood.  As an easy fix, Daystar Products has introduced the Hood Wrangler, polyurethane replacements for the stock rubber hood latch.  Installation is easy, less than an hour from start to finish, provided you have a the right stuff on hand. The Daystar Products replacement kit includes necessary parts and instructions.  What the instructions don’t tell you is the size of nut holding the hood latch.  And, more important, the location of the nut provides a challenge to fit a wrench and loosen the nut. First, it is easy to find where the nut is located.  Yes, there is plenty of room around it, but, access is tight.  To make it real easy to replace the hood latch, remove the radiator or the fenders; slightly more than a one hour job. [url=http://ftp.4x4voice.com/index.php?option=com_content&view=article&id=1240:daystar-hood-wrangler-install&catid=72:jeep-tech-pages&Itemid=53#discuss-1240]Read full article[/url]

John Stewart Managing Editor - 4x4Voice - 4x4Wire - MUIRNet.net Natural Resources Consultant - California Four Wheel Drive Association - http://www.cal4wheel.com Board of Directors - BlueRibbon Coalition http://www.sharetrails.org

Comment
There are no comments made yet.


There are no replies made for this post yet.
However, you are not allowed to reply to this post.