About you, your 4x4 and access

Why Register?

Creating a profile on the 4x4Wire.com portal is not (and never will be) a requirement to browse the site, but once registered you can log in and:

  1. Create articles: whether 4WD Tech, Maintenance, Trailride reports, or any other category, you can publish your knowledge and experiences here on 4x4Wire.com.
  2. Upload Photos: Show off in our Reader's Rides section, upload trailride photos, and share your tech photos.
  3. Create and post Events: planning a trailride, work day, know of a meeting, going to a show? Registered users can post virtually any event, and also help build a database of trailride locations.

4x4Wire.com will protect the information submitted when you create a profile - we will not share it with anyone, and we will only email you with significant site announcements.

So go ahead, create a profile, and start sharing your knowledge, photos, and events!

  72347 Hits

Porting the Superflow MV50 Compressor

The piston upon initial disassembly

I wanted to find out whether there was anything wrong with mine, and whether I could do anything to get sustained flow again. For disassembly, all that is required is a 4mm allen wrench or driver for the head bolts, and a 14mm wrench for the output fitting.

Disassembly of the compressor piston and head takes a minute. Once the four studs are removed, everything else can be removed by hand. Not surprisingly, when I pulled the piston head off, I found very visible signs of overheating. I cleaned up the piston, the skirt, and the head, and used a very thin application of high-quality grease on the piston.

After studying the head for a few minutes, it became obvious that there was room to port the intake and output ports. Each port is covered by a flexible steel flap, and when the piston is on the downstroke the flap opens to allow air in to the chamber. Then when the piston is on the upstroke, the compressed air forces open the output flap. These flaps make excellent templates for the porting.

Using a router bit on a Dremel, I removed the rib and a bit of extra material on the intake port for a roughly 25% gain in flow capacity. I used the Dremel to effectively double the size of the output port.

 After a good cleaning, I reassembled the compressor, and using parts from leftover projects installed a brass, barbed output; and a new coiled hose (the original hose fittings leaked at the assembly that is screwed onto the valve stem). Then I sourced a zooty Type R filter to replace the original plastic and sponge filter for more airflow and a touch of bling.

The MV50 is rated at 150 psi and 2.5 CFM and when new, it could inflate a 33" tire from 18psi to 35psi in roughly 3 minutes. After this cleaning and porting, the MV50 sustained airflow over multiple fills and consistently aired my 33's from 18psi to 35psi in just over two minutes per tire. This is a very satisfactory result for 1 hour of time and $7.

Continue reading
  23186 Hits

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting. Copyright (c) 1999-2020 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission. You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material. All corporate trademarks are the property of their respective owners.